example of electrical power

1 Definition of Electrical Power

Electrical power is the rate at which electrical energy is delivered or consumed in a circuit. If a device has an electrical potential difference denoted by V and current denoted by I, then the instantaneous electrical power P(t) is defined as

(1)

The SI unit of P is the watt, denoted W, where one watt equals one joule per second.

2 Ohm’s Law and Resistive Load

Consider a simple series circuit consisting of a voltage source V (t) and a resistor R. For a purely resistive load, the current and voltage are in phase and Ohm’s law applies at every instant:

(2)

We will assume that the source voltage is sinusoidal with angular frequency ω and amplitude V ₀, so that

(3)

Substituting into Ohm’s law gives the instantaneous current:

(4)

3 Instantaneous Power in a Resistor

Using the definitions above, the instantaneous power delivered to the resistor is

P(t)	= V (t)I(t)	(5)
	= V 0 sin(ωt)	(6)
	= sin 2(ωt).	(7)

This equation shows that the instantaneous power oscillates at twice the fundamental frequency. The power is always nonnegative for a resistive load, consistent with the fact that a resistor only consumes energy; it does not return energy to the source.

4 Average Power

The average power ⟨P⟩ over one full cycle is obtained by integrating P(t) with respect to time over the period T = 2π∕ω and dividing by the period:

(8)

Substituting P(t) yields

(9)

Using the trigonometric identity sin ²(𝜃) = , we find

⟨P⟩	= ∫ 0T dt	(10)
	= .	(11)

The cosine term averages to zero over a full cycle, leaving one half of the peak squared voltage divided by the resistance.

5 Root Mean Square Values

It is common to express average power in terms of root mean square (rms) values. Define the rms voltage V _rms and rms current I_rms as

V rms	= ,	(12)
Irms	= = .	(13)

Using these definitions, the average power becomes

(14)

which is the standard form used in circuit analysis for a purely resistive load.

6 Interpretation and Units

In our example, the voltage and current are in phase, so the average power represents real energy delivered to the resistor each second. The average power in watts equals the rate of conversion of electrical energy into heat in the resistor.

7 Conclusion

We computed the instantaneous and average electrical power delivered to a resistive element in response to a sinusoidal source. The average power is one half the peak voltage squared divided by the resistance and may be expressed as the product of rms voltage and rms current. These results are standard in electrical engineering and physics and provide a basis for more complex analysis of circuits with time-varying sources.

References